How To Make A Beaded Plant Hanger

How To Make A Beaded Plant Hanger

How To Make A Beaded Plant Hanger. Take a piece of plant wire and fold it in half over the two strings. Add 4 large beads onto your craft wires.

How To Make A Macrame Plant Hanger With Beads References
How To Make A Macrame Plant Hanger With Beads References from ting.totobts.net

Get your remaining three beads and string them on each pair of strings. Add a bead to each pair. This will be the top for hanging the plant from.

Split Your Wires Into Four Separate Sections.


Starting about 2/3s down the length of the twine and thread 5 beads onto the pairs of the twine. Knot the twine just below each of the 5 beads. All you need to do is make sure that the holes in the beads are large enough for the cording to strand through easily.

Last, Tie All Three Strands Together At The Top And Create A Loop For Hanging.


Tie off the top ends in a knot to make a loop to hang your hanger. Add a few more wood beads, leaving enough jute to tie a loop to secure to the hanger. Finally take the other rope from c and add it to the extra rope from a and add a bead.

To Add The Beads You Simply Slide Them Onto The Cording Between Or In The Middle Of Knots.


String your wood beads, any pattern you like will work. This will be the top for hanging the plant from. Technically you can stop here, but the pot could technically fall out, so i just made another shorter string of beads and wrapped it around my pot, on the outside of the plant hanger, then tied it.

Then, By Sticking A Screwdriver Through The Two Loops, He Twisted The Wire Until Approximately Six Inches Of The Wire Was Meshed Together In This Manner, Leaving Four Wires Ready To Be Hooked Onto The Planter’s Brackeats.


About 10″ below the bottom row of beads, tie one secure overhand knot with all of the strings. How to make a beaded plant hanger materials. How to posted by lena.

Get Your Remaining Three Beads And String Them On Each Pair Of Strings.


I found it was helpful to hang the twine from a door knob and work with gavity to do the next steps, but you could also work on a flat surface. Insert the wire into the bead and pull the string through with the wire. There was already a plant cup hook in the ceiling that i simply hung this from.

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel